Kromschroder BCU 570WC1F1U0K1-E, burner control unit (88661333)

Kromschroder burner control unit
Housing for control cabinet installation, for controlling, igniting and monitoring modulating forced draught burners. For continuous operation with ionization control or UV control using Kromschroder UV sensor UVD. Intermittent operation with UV sensor UVS. Display of the program status, unit parameters and flame signal. Manual operating mode. Diagnosis and adjustment of unit parameters via optical interface using PC software BCSoft.
Series 570
EU certified, certified for systems up to SIL 3 (compliant with PL e)
Mains voltage: 230 V AC, 50/60 Hz
With valve proving system
Modulating capacity control with interface for actuator IC
Flammen?berwachung mit Ionisations- oder UV-Signal
Screw connection terminals
Individual packaging
Flame control: ionization
01 Burner switch-off threshold: 2 micro A
07 Burner start-up attempts: 1
09 Restart: no
10 Emergency stop with fault lock-out
12 High gas pressure protection with fault lock-out
13 Low pressure cut-off with fault lock-out
15 Air deficiency cut-out with fault lock-out
19 Safety time during operation: 1 s
40 Capacity control with IC 20
30 Fan run-up time tGV: 0 s
32 Air flow monitoring during controlled air flow off, maximum capacity
33 Start-up with pre-purge: yes (depending on P34 Pre-purge time tPV)
34 Pre-purge time tPV: 300 s
35 Air flow monitoring during pre-purge with fault lock-out
37 Post-purge time tPN: 0 s
43 Over-run up to min. capacity: off
44 Controller enable signal delay time tRF: 0 s
51 Valve proving system: tightness test before start-up
52 Relief valve (VPS): V2
56 Measurement time Vp: 50 s
59 Valve opening time V1 (tL1): 3 s
61 Minimum burner on time tB: 0 s
62 Minimum pause time tBP: 0 s
63 Switch-on delay time tE: 0 s
67 Operating time in Manual mode limited to 5 min.
77 User-defined password
78 Burner application: burner
80 Fieldbus communication: with address check
93 Pre-ignition time tVZ: 1 s
94 1st safety time on start-up: 3 s
95 Flame proving period 1 tFS1: 0 s

Replacing a Kromschroder BCU 570WC1F1U0K1-E, 88661333 burner control unit is a good solution to make your equipment work again. We offer a wide range of Kromschroder spare parts for burners, gas trains etc. We supply original Elster (Kromschröder) & Honeywell (Maxon) products.

If you have any queries about Kromschroder burner control or any other Kromschroder spare parts, please write us at 624burner@gmail.com, quoting the item code 88661333.